Digital Chromatic Guitar Tuner

Controls and Functions
	1. Power Switch for Tuner On / Off (Auto Power Off After 20 Min.) 2. Tuning Guide LED 3. Liquid Crystal Display 4. Internal Microphone for Acoustic Instruments 5. Pitch Button for Pitch Adjustment 6. Note Button for Tuning Note Selection. 7. Mode Button for Auto Mode Selection. 8. Flat Button for Flat Selection. 9. Input Jack for Electric Instruments.

A. Mode:  Auto Chroma, Auto Guitar, Auto Bass, Auto Violin B. Note Name C. Tuning Meter D. Reference Pitch E. Flat Mark

For Accurate Tuning

* Do not operate the tuner nearby sound equipment such as radio or television.
* When you tune electronic instruments, locate the volume level at the center position.
* Do not pluck loudly and heavily.
* For quick tuning of next string, press all strings with finger lightly after tuning to cut input.

Auto Tuning in Auto Mode

1. Electric Instruments: Connect output cord of instrument into IN jack on tuner.
Acoustic Instruments: Locate tuner near instruments.

2. Press POWER button to turn on.  LCD lights up and set Auto Guitar and Pitch 440Hz automatically.

3. Select mode you wish to tune.  Each press will indicate Auto Guitar - Auto Bass.

4. If necessary, adjust reference pitch by pitch button.

5. If you use a Capo for your guitar, you can tune the guitar by using the FLAT tuning function.

6. Start tuning from low frequency sound.

7. If the tuning sound is out of -50 or +50 cent range, adjust the instrument until one of red LED lights up and tuning note you wish to tune is shown on LCD.

8. If one of red LEF lights up, tighten or loosen the instrument slowly to the approach needle of meter to center position.

9. When the sound is in tune, the needle of meter stops at the center position and green LED lights up.